It’s possible for you to construct a spherical column with molding; that is how several woodworkers do it. Columns require to be completely symmetrical — even when they are only for aesthetics and are big. It is really hard to mill a big log or tree down right into a column. It it takes lathes that are big, and even columns that are sound will split or warp. Columns created from molding appear fashionable and so are used in houses throughout the country. But In Case you want one for the house, it can be built by you if you’ve some thick bits of molding.
A tablesaw blade to 30 levels. Set the fence at therefore that it trims sufficient substance off one aspect of the molding to create the miter angle. Reset the fence and trim the other aspect of every bit of molding to that particular angle. You need to now have six parts of molding using a 30-degree angle on either side.
Cut a 6 inch circle, centered, right into a bit of 3/4 by-18-by-18-inch plywood using a jigsaw. Draw it onto the plywood using a compass. Drill first 8-inch cordless drill and drill bit. The jigsaw blade and cut the circle out.
Mix the resin glue in line with the instructions of the manufacturer. Pour the glue.
Cut the piece of plywood in two to produce two pieces of plywood using a semi-circle on one aspect. Clamp the items to the very best of a work-table using the semi-circle side-facing up, on their edges. The parts should be parallel, 36-inches aside. Use a little hand clamp to contain the the leading fringe of of the items to the tabletop. You ought to be looking in a kind of cradle.
Run a bead of glue-down both 3-0-diploma sides of the little bit of molding. Place it in the base of the cradle. Run beads of glue-down another little bit of molding. Place it on proper or the left of the piece. Glue still another piece and spot it on one other side. This can complete the bottom-half of the column.
Run beads down another piece of glue. Place it on the right or left side of the bottom-half of the column. Shoot a pin nail 1 inch in the edge, angled down s O that it penetrates through both parts. Shoot a pin nail during another end in much the same.
Run glue-down either side of the piece that is next. Place it on another side. Pin nails through both ends. Run beads down either side of the piece of glue. Drop it into spot involving the two parts.
Wrap the column with six ny-lon strap clamps spaced the amount of the column down. Tighten them till glue oozes out from every one of the cracks. Wait 2 4 hrs for the glue to dry.
Remove the clamps. Scrape off any residual glue having a glue scraper. Sand the column with 100-grit sand-paper connected to some hand block. Paint or stain and lacquer the column. You ought to have an 8 foot column roughly 6″ in diameter.