A hardwood flooring provides a natural coating in your home. Like any other flooring surface a hardwood flooring becomes worn down over time. You can revitalize the surface by simply staining the floor and stripping the old finish. This really is a labor-intensive project, but upon successful completion you will have a beautifully renovated hardwood flooring that you can admire with pride.
Remove in the room. Cover in the room and shut all doors to prevent dust. In case you have entryways that do not have doors, pay for the entryways.
Analyze the floor for cracks or nicks from the boards. By employing wood putty fill any cracks. Fill the cracks and smooth the surface just as much as you can using the putty knife. It does not have to be perfect since you need to sand the floor, but it might supply for a neater finish.
Put on safety goggles, a mask and ear protection, then sand the part of the floor using a sander. Keep the drum off of the floor until the machine is turned on, then gradually lower the drum. So you don’t dig into the floor begin walking the sander as soon hits the floor. Once you stop moving, lift the drum immediately. When sanding, Proceed with the grain of the wood, and create two moves.
By using an edge sander sand the perimeter of the floor and any sections you couldn’t reach with the sander. Sand using a semicircular movement, moving from left to right. Use coarse sandpaper.
Sand the floor again using the drum sander and border sander, now using a medium-grit sandpaper (50 to 60 grit). Use the same technique that you used when sanding with the paper.
Sand the floor one last time, now using fine-grit (80 to 100 grit) sandpaper.
Vacuum the dust from around the room, such as the walls and ceiling, while it melts to prevent the dust.
Run a floor buffer equipped with a fine abrasive display (100 to 120 grit) on the surface of the floor. Begin buffing the floor and go with the grain of the wood.
Begin applying the stain to the floor along the wall farthest from the door or entryway — you do not need to paint yourself. Dip a clean rag to the stain and cut in along the edges of the floor, starting in 1 corner. Apply the blot moving in the direction of the grain, and wash the excess stain with a clean rag up. (You might want an assistant to do that.) Change rags frequently and wear safety goggles, gloves and a mask when applying the stain. Allow the stain to dry immediately.
Apply a water-based urethane complete or a polyurethane (oil-based) end to the floor. Apply the finish to the floor the same way that the stain was implemented by you, but use natural bristle brush or a foam applicator rather than the rags you used when applying the stain. Allow the finish coat to dry to the moment. Polyurethane will need an overnight period, although A urethane can dry in a few hours.
Remove from the floor using a clean, moist cloth. Apply finish and allow it to dry. Repeat this process has the range of coats that the manufacturer recommends. Water-based finishes require additional coats.