The Way to Tile Over Cracked Floors

There is A tile floor stable and only as robust as the subfloor where it’s installed. Cracks in concrete are a sign of a problem. Cracks mean motion, and a tile floor isn’t meant to move. Should you install vinyl then most probably, the crack will show up in the tile. To avoid a crack from forming in the tile, then you need to supply ways to permit a little bit of motion in the floor without transferring it.

Mix the mortar in accordance with package directions, replacing the water additive to give strength and flexibility to the mortar.

Cut strips of ceramic tape, made to protect joints in cement backer board, to fit over the crack. If the crack is directly, cut just one piece that is long. If the crack is jagged, cut the tape into smaller bits. The crack does not need to remain beneath the tape’s center so long as the crack wills span.

Force the thin-set to the crack using a trowel, filling the crack flush with the concrete. Smooth the mortar apartment with the flat edge of the trowel.

Place the pieces of tape you ready over the crack. Work in spans so you can complete all steps prior to the starts to set. The latex will also make the mortar to stiffen. Gently over the tape together with the flat edge of the trowel and push it into the thin-set onto the concrete’s surface.

Trowel mortar about the tape. Force the mortar till you’ve got an almost flat field of tape and mortar spanning the crack, and smooth it out again. Allow the mortar to set.

Sand over the tape using a rubbing stone, hammering the mortar and tape job and smoothing out any rough spots. A little or brick piece of cinder block also work. You’re now ready to tile the floor as ordinary.

See related